DPC III Generators Technical Data

Application Notes
For DPC III Series Generators

These documents describe connector pin assignments and signal functions for various connectors on Dukane 15 kHz, 20 kHz, 30 kHz, 40 kHz, 50 kHz, and 70 kHz DPC III series generators.

AN300

J801 I/O Interface
Lists the connector pin assignments of the generator rear panel Basic I/O connector J801. Input signals that are covered include Automation Input, Cycle Stop, Ground Detect, and Remote Setup Inputs. Output signals that are covered include Good Part, Suspect Part, Bad Part, and Ready. Example circuit connection diagrams are also included.

AN301

J902 Base Interface and J802 Automation Stop Interface
Lists the connector pin assignments of the generator rear panel Base Interface connector J902 and Automation Stop Interface connector J802. Input signals that are covered include Automation Input, Emergency Stop, and Manual Activation Switch Inputs. Example circuit connection diagrams are also included.

Adobe Acrobat Reader must be installed on your computer to view PDF files. To download a free copy, go to the Adobe download site.

Please refer to DPC III manual (403-541) for further information