DPC II Plus Generators Technical Data

Application Notes
For DPC II Plus Series Generators

These documents describe connector pin assignments and signal functions for various connectors on Dukane 15 kHz, 20 kHz, 30 kHz, 40 kHz, 50 kHz, and 70 kHz DPC II Plus series generators.

AN200

System Input Interface
Lists the connector pin assignments of the generator rear panel System In connector. Input signals that are covered include Automation Input, Press Control, Automation Stop/End of Weld, and MPC Probe/Setup Selection Bits. Example circuit connection diagrams are also included.

AN201

J902 Base Interface
Lists the connector pin assignments of the generator rear panel Base Interface connector J902. Input signals that are covered include Automation Input, Emergency Stop, and Manual Activation Switch Inputs. Example circuit connection diagrams are also included.

AN202

System Output Interface
Lists the connector pin assignments of the generator rear panel System Output connector. Output signals that are covered include Good Part, Bad/Suspect Part, Ready, In Hold, the Status Driver, Ultrasound Status, Overload Fault, Over Temperature Fault, and System Fault. Example circuit connection diagrams are also included.

AN203

Automation Interface Guidelines for Multi-Probe Controller (MPC)
Lists the MPC related connector pin assignments of the generator rear panel System Input and Output connectors. A process flowchart, timing diagrams, and example circuit connection diagrams are also included.

Adobe Acrobat Reader must be installed on your computer to view PDF files. To download a free copy, go to the Adobe download site.

Please refer to DPC II Plus manual (403-551) for further information